Actividad
 
Avisos
Vaciar todo
Iancun
Iancun
Grupo: Registrado
Registrado: 2017/04/11
Eminent Member
2
Blown Mosfets

En el foro Hardware, firmware and software help

hace 6 years
Yeah this is pretty disappointing. I understand that the cir...

En el foro General discussion, announcements and releases

hace 6 years
Powder coated sheet

En el foro Hardware, firmware and software help

hace 6 years
Over-extrusion on MK2.5 with Slic3r PE?

En el foro Hardware, firmware and software help

hace 7 years
MK52 bed on MK2

En el foro General discussion, announcements and releases

hace 7 years
I have the exact same problem - the printer prints fine, but...

En el foro Prusa i3 kit (Archive)

hace 7 years
Has anyone tried the Matt PrintBite on their MK2? I can't fi...

En el foro Others (Archive)

hace 7 years
I've had a look at my original prints and I can see the same...

En el foro Others (Archive)

hace 7 years
Yep, I've even manually unspooled a length in advance so tha...

En el foro Others (Archive)

hace 7 years
I've just replaced the IGUS bushings with new linear bearing...

En el foro Others (Archive)

hace 7 years
It's the RJ4JP - they seem to move very smoothly and have no...

En el foro Others (Archive)

hace 7 years
Z banding issues?

En el foro Others (Archive)

hace 7 years
Poor surface finish from PEI - any alternatives?

En el foro Others (Archive)

hace 7 years
Thanks for the feedback :). Some slicers (notably KISS) ov...

En el foro Others (Archive)

hace 7 years
OctoPrint vs SD Card

En el foro Others (Archive)

hace 7 years
I've remixed the MK2S x-carriage so that the RJ4JP bushings ...

En el foro Hardware, firmware and software help

hace 7 years
Could you please let me know where you can buy these from, a...

En el foro Prusa i3 kit (Archive)

hace 7 years
Thanks for the reply. Yes, I tried with a hotter temperature...

En el foro Print tips (Archive)

hace 7 years
First Layer problems with PETG

En el foro Print tips (Archive)

hace 8 years
Do the parcels take a while to get picked up - mine has been...

En el foro General discussion, announcements and releases

hace 8 years
Página 1 / 2
Compartir: