Activity
 
Notifications
Clear all
Iancun
Iancun
Group: Registered
Joined: 2017/04/11
Eminent Member
2
Blown Mosfets

In forum Hardware, firmware and software help

6 years ago
Yeah this is pretty disappointing. I understand that the cir...

In forum General discussion, announcements and releases

6 years ago
Powder coated sheet

In forum Hardware, firmware and software help

6 years ago
Over-extrusion on MK2.5 with Slic3r PE?

In forum Hardware, firmware and software help

7 years ago
MK52 bed on MK2

In forum General discussion, announcements and releases

7 years ago
I have the exact same problem - the printer prints fine, but...

In forum Prusa i3 kit (Archive)

7 years ago
Has anyone tried the Matt PrintBite on their MK2? I can't fi...

In forum Others (Archive)

7 years ago
I've had a look at my original prints and I can see the same...

In forum Others (Archive)

7 years ago
Yep, I've even manually unspooled a length in advance so tha...

In forum Others (Archive)

7 years ago
I've just replaced the IGUS bushings with new linear bearing...

In forum Others (Archive)

7 years ago
It's the RJ4JP - they seem to move very smoothly and have no...

In forum Others (Archive)

7 years ago
Z banding issues?

In forum Others (Archive)

7 years ago
Poor surface finish from PEI - any alternatives?

In forum Others (Archive)

7 years ago
Thanks for the feedback :). Some slicers (notably KISS) ov...

In forum Others (Archive)

7 years ago
OctoPrint vs SD Card

In forum Others (Archive)

7 years ago
I've remixed the MK2S x-carriage so that the RJ4JP bushings ...

In forum Hardware, firmware and software help

7 years ago
Could you please let me know where you can buy these from, a...

In forum Prusa i3 kit (Archive)

7 years ago
Thanks for the reply. Yes, I tried with a hotter temperature...

In forum Print tips (Archive)

7 years ago
First Layer problems with PETG

In forum Print tips (Archive)

8 years ago
Do the parcels take a while to get picked up - mine has been...

In forum General discussion, announcements and releases

8 years ago
Page 1 / 2
Share: