Français
Forums
Membres
hyiger
Activité
 
Notifications
Clear all
hyiger
hyiger
Groupe: Enregistré
A(ont) rejoint: 2025/07/14
Famed Member
Profil Activité
Try a different memory stick. The ones supplied by Prusa see...

Dans le forum Hardware, firmware and software help

 il y a 8 months
Same problem, did many prints successfully until I tried one...

Dans le forum Hardware, firmware and software help

 il y a 8 months
First week using Core One, lots of issues. Some tips for peo...

Dans le forum Hardware, firmware and software help

 il y a 8 months
I asked the same of Prusa tech support and they replied with...

Dans le forum Hardware, firmware and software help

 il y a 8 months
Problem with brand new Prusa Satin plate

Dans le forum Assembly and first prints troubleshooting

 il y a 8 months
Thanks. I was in expert mode but neglected to scroll down. I...

Dans le forum Assembly and first prints troubleshooting

 il y a 8 months
When changing colors mid-print, the filament oozes out of no...

Dans le forum Assembly and first prints troubleshooting

 il y a 8 months
It's a brand new sheet from Prusa and I've only done 2 print...

Dans le forum Assembly and first prints troubleshooting

 il y a 8 months
Upgraded my MK4S to Core One and getting waves in the first ...

Dans le forum Assembly and first prints troubleshooting

 il y a 8 months
I went with gluing them on with Gorilla Glue Clear Grip. Bon...

Dans le forum Assembly and first prints troubleshooting

 il y a 9 months
Yup, it was only a fluke. Adding the gcode patch worked for ...

Dans le forum Assembly and first prints troubleshooting

 il y a 9 months
I completed the MK4S to CORE ONE conversion with 6.3.3 firmw...

Dans le forum Assembly and first prints troubleshooting

 il y a 9 months
Page 138 / 138
Partager :