Prusa3D Forum

Notifications

Clear all

Humble Bazooka

Group: Registered

Joined: 2016/12/24

Eminent Member

	@cwbullet Seems fine to me when I click it but even so, my q... In forum PrusaSlicer	5 years ago
	Adding supports at the same points after you re-open PrusaSl... In forum PrusaSlicer	5 years ago
	To be honest I also had some weird issue with print not stic... In forum Others (Archive)	8 years ago
	Hi! Definitely no expert - but did you check the hobbed gea... In forum Others (Archive)	8 years ago
	Pla print looks to be getting close to where it should be. ... In forum Others (Archive)	8 years ago
	The print that had previously fail, try printing it in the c... In forum Others (Archive)	8 years ago
	Can you now print the batman using prusa PLA. The batman in ... In forum Others (Archive)	8 years ago
	I didn't even think of a z endstop. That's kind of important... In forum Others (Archive)	8 years ago
	At this point in time I think it would be worth a nozzle cle... In forum Others (Archive)	8 years ago
	I've actually done all of this already. This was one of the ... In forum Others (Archive)	8 years ago
	Can you print the batman from the SD card, 1st layer only an... In forum Others (Archive)	8 years ago
	Thanks for the info! I always thought forcing filament in or... In forum Others (Archive)	8 years ago
	Thanks for the reply David. Are you doing cord pulls after ... In forum Others (Archive)	8 years ago
	I am sure you have done this but here is what helped me when... In forum Others (Archive)	8 years ago
	I too have a "wobble" out of the box with my Z leadscrews. I... In forum Prusa i3 kit (Archive)	8 years ago
	I agree looks like the z isn't low enough.... Bob It's defi... In forum Others (Archive)	8 years ago
	It looks like your nozzle is too high. One thing that might ... In forum Others (Archive)	8 years ago
	Increased failure rate with all filament In forum Others (Archive)	8 years ago
	The fact that I'm reading posts about people having the same... In forum Others (Archive)	9 years ago
	I had the same exact issue and it wasn't the PINDA's height ... In forum Others (Archive)	9 years ago

Forum Statistics

585 Forums

67.9 K Topics

475.9 K Posts

9 Online

75.5 K Members

Latest Post: Help printing with PC Blend without warping Our newest member: klong Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed