Notifications
Clear all
Hub0001
Group: Registered
Joined: 2019/02/22
Active Member
1
|
issues after firmware upgrade to 13.13 In forum Hardware, firmware and software help |
2 years ago | |
| @joantabb Thank you for the info. it has started when I did ... | 6 years ago | |
| Getting “gcode not sliced for this machine” warning message ... | 6 years ago | |
|
Thank you for the reply. I did exactly that I flashed with t... In forum Hardware, firmware and software help |
7 years ago | |
|
Filament Sensor problems In forum Hardware, firmware and software help |
7 years ago | |
|
filamament sensor disabled In forum Hardware, firmware and software help |
7 years ago | |
| thanks cards were up at 64G | 7 years ago | |
| So card compatibility | 7 years ago |