Notifications
Clear all
Hobby Hoarder
Hobby Hoarder
Skupina: Registrovaný
Přidal se: 2017/04/12
Trusted Member
3
Sorry to bump an old topic, but I'm possibly having the same...

In forum Others (Archive)

před 7 years
I had a similar issue with the fan not working and I didn't ...

In forum Others (Archive)

před 7 years
Is the "one side" the side away from the cooling fan ("!HOT!...

In forum Prusa i3 kit (Archive)

před 7 years
Started getting strange small gaps on the outer walls, but o...

In forum Prusa i3 kit (Archive)

před 7 years
Gaps in a sloping/angled wall

In forum Print tips (Archive)

před 7 years
Hi, I open a stl file in Prusacontrol, and i thought that i...

In forum Hardware, firmware and software help

před 7 years
So, I have been thinking about your problem. Your PINDA pro...

In forum Prusa i3 kit (Archive)

před 7 years
I'm sorry about what happened. I can only help with the clea...

In forum Prusa i3 kit (Archive)

před 7 years
I recall a discussion of having the heat break cooling fan p...

In forum Prusa i3 kit (Archive)

před 7 years
There seems to be some confusion about the Live-Z on the for...

In forum Prusa i3 kit (Archive)

před 7 years
Your probe height seems to be correct. Did you turn on the ...

In forum Prusa i3 kit (Archive)

před 7 years
Hey Sergey, thanks for replying. Could you please elaborate...

In forum Prusa i3 kit (Archive)

před 7 years
set your pinda height so your live z adjust is around 600-80...

In forum Prusa i3 kit (Archive)

před 7 years
OK, so "Live Z Adjustment" is used to correct the probe sett...

In forum Prusa i3 kit (Archive)

před 7 years
I am quite confused. Your Live-Z value, IS the distance fro...

In forum Prusa i3 kit (Archive)

před 7 years
A few comments. Your PINDA sensor is much too low. It is ...

In forum Prusa i3 kit (Archive)

před 7 years
A few comments. Your PINDA sensor is much too low. It is ...

In forum Prusa i3 kit (Archive)

před 7 years
as already mentioned inside my thread and a lot of other pos...

In forum Prusa i3 kit (Archive)

před 7 years
Z height varies wildly between prints (pic included)

In forum Prusa i3 kit (Archive)

před 7 years
I'm afraid not. The only thing that most software can check ...

In forum Software (Archive)

před 7 years
Stránka 2 / 3
Share: