Notifications
Clear all
henrysilverio
henrysilverio
Group: Registered
Joined: 2022/03/19
Active Member
1
Maybe Prusa should address this on the forum.

In forum General discussion, announcements and releases

2 years ago
One has to respect the voice of direct experience. I am sti...

In forum General discussion, announcements and releases

2 years ago
Thank you. I am kind of new at 3d printing and there are a ...

In forum General discussion, announcements and releases

2 years ago
I just ordered an mk 4 and am beginning to have doubts. The...

In forum General discussion, announcements and releases

2 years ago
Skydiving is not for me. In the 70s a friend and I bought a...

In forum How do I print this? (Printing help)

2 years ago
Thanks for the tip. Will try with .4 nozzle.

In forum How do I print this? (Printing help)

2 years ago
Can I change nozzle sizes during a print?

In forum How do I print this? (Printing help)

2 years ago
Dense Support Structures in Simplify3D

In forum Cura, Simplify3D, Kisslicer, ...

2 years ago
Thanks for sharing. Your technique is easy and effective.

In forum General discussion, announcements and releases

2 years ago
How about the Montana State Fair? Farmers and ranchers are ...

In forum General discussion, announcements and releases

2 years ago
That happened to me but it was my fault. I had run out of f...

In forum Assembly and first prints troubleshooting

2 years ago
Hi Joan, here is the link to the entire project, 7 files in ...

In forum How do I print this? (Printing help)

3 years ago
I would be glad to. Would you also like the roses and other...

In forum How do I print this? (Printing help)

3 years ago
I printed it standing up with automatic supports generated. ...

In forum How do I print this? (Printing help)

3 years ago
Hi Joan, I used supports and slowed down printing times just...

In forum How do I print this? (Printing help)

3 years ago
Thank you, Joan, and very kind of you to reply. I will give...

In forum How do I print this? (Printing help)

3 years ago
Advice Appreciated on Misprint

In forum How do I print this? (Printing help)

3 years ago
Share: