Notifications
Clear all
harrysamuel
harrysamuel
Group: Registered
Joined: 2018/05/14
Active Member
1
I have used many powder coated sheets, they all work well, a...

In forum Assembly and first prints troubleshooting

4 years ago
It looks like you completely understood my post. thanks for ...

In forum Others (Archive)

5 years ago
not sure what you mean that I am troll, just a tired old man...

In forum Others (Archive)

5 years ago
the thread was about crazy slow shipping, and other things, ...

In forum Others (Archive)

5 years ago
Why close the thread, Prusa needs to get moving, and fix all...

In forum Others (Archive)

5 years ago
Peter, Thanks for your reply, I have found several things ...

In forum Others (Archive)

5 years ago
Lets face it Joe Prusa is the Donald Trump of 3D printers, g...

In forum Hardware, firmware and software help

5 years ago
Prusa is full of S$%^. I had XYZ printing printers which had...

In forum Hardware, firmware and software help

5 years ago
Ok, after months of using my Prusa I have learned many thing...

In forum Assembly and first prints troubleshooting

5 years ago
If you are using Slic3r PE, and setting the bed to 65 you wi...

In forum Hardware, firmware and software help

6 years ago
When you order ALWAYS expect at least a 6 to 12 week wait fo...

In forum General discussion, announcements and releases

6 years ago
I gave up, I finally pulled out the glue stick, and I'm tryi...

In forum Assembly and first prints troubleshooting

6 years ago
Thanks to John, and his posting of a link to the manual, and...

In forum Others (Archive)

6 years ago
John, thank you for the information. It is very helpful.

In forum Others (Archive)

6 years ago
I guess I should add to my question, does the PRUSA track to...

In forum Others (Archive)

6 years ago
My XYZ printer needed a small repair after 1340 hours, anoth...

In forum Others (Archive)

6 years ago
I guess I'm going to upset a lot of people I just went throu...

In forum Others (Archive)

6 years ago
Has the ghosting issue been fixed yet? I'm thinking of orde...

In forum Others (Archive)

6 years ago
Share: