Activity
 
Notifications
Clear all
gronax
gronax
Group: Registered
Joined: 2017/10/06
Active Member
1
Clogged extruder, again and again

In forum Assembly and first prints troubleshooting

6 years ago
Ok...wow...this was a journey! I discovered that I had a l...

In forum Assembly and first prints troubleshooting

6 years ago
OK...for the record, the problem was I hadn't properly assem...

In forum Assembly and first prints troubleshooting

6 years ago
Continued..... Tried the second filament path and that load...

In forum Assembly and first prints troubleshooting

6 years ago
Problem loading filament first time

In forum Assembly and first prints troubleshooting

6 years ago
Yep...Prusa PLA. Smells like PLA, feels like PLA..... Incr...

In forum Assembly and first prints troubleshooting

6 years ago
Ok...looks a bit better. - Increased temp to 225 from 215 -...

In forum Assembly and first prints troubleshooting

6 years ago
I spoke too soon! It seems that I have a periodic under ext...

In forum Assembly and first prints troubleshooting

6 years ago
Got some time to work on the printer today. I opened the ex...

In forum Assembly and first prints troubleshooting

6 years ago
your filament running free? Yes. From the top using a roll...

In forum Assembly and first prints troubleshooting

6 years ago
Under extrusion and clogging

In forum Assembly and first prints troubleshooting

6 years ago
Thanks. The rods seemed fine. I'm just putting this down...

In forum General discussion, announcements and releases

6 years ago
Y axis gunk / bearings

In forum General discussion, announcements and releases

7 years ago
Share: