Prusa3D Forum

Notifications

Clear all

Grok

Group: Registered

Joined: 2021/05/28

Active Member

	I had an "X" rod wear issue too, my rods were parallel thoug... In forum Hardware, firmware and software help	3 years ago
	Since I have still seen people are experiencing upper "X" ro... In forum Hardware, firmware and software help	3 years ago
	Found this longer bearing that I've used to replace the 2 se... In forum Hardware, firmware and software help	3 years ago
	Some good ideas there Dan. Other things to consider are; Rod... In forum Hardware, firmware and software help	3 years ago
	I have around 30 hours on my Mark3s+ printer and I too have ... In forum Hardware, firmware and software help	3 years ago
	Yes their filament is expensive. The printer price was OK an... In forum Assembly and first prints troubleshooting	3 years ago
	Put a check in the last box in the setup wizard "View Mode" ... In forum PrusaSlicer	3 years ago
	Yes, Makerwiz. About Makerwiz \| Makerwiz - 3D Printing Shop ... In forum Assembly and first prints troubleshooting	3 years ago
	New Member - Just assembled, tested, calibrated, and made my... In forum Assembly and first prints troubleshooting	3 years ago

Forum Statistics

559 Forums

62.8 K Topics

442.5 K Posts

20 Online

67.4 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed