Čeština
Fóra
Uživatelé
Grimmy579
Aktivita
 
Notifications
Clear all
Grimmy579
Grimmy579
Skupina: Registrovaný
Přidal se: 2020/10/21
Eminent Member
2
Profile Aktivita
@area51 Yeah finished printing my cube and X,Y are pretty go...

In forum PrusaSlicer

 před 4 years
@diem It not usual for me to use 100% infill to be honest bu...

In forum PrusaSlicer

 před 4 years
Not sure if that’s a thing? But I’m guessing the motor moves...

In forum PrusaSlicer

 před 4 years
@area51 Thanks for the reply. Even before I get to my infil...

In forum PrusaSlicer

 před 4 years
1.0mm 20x20.3mf

In forum PrusaSlicer

 před 4 years
Over Extrusion issue (help)

In forum PrusaSlicer

 před 4 years
Once again. Thank you very much! I’ll give it a go this even...

In forum PrusaSlicer

 před 4 years
I do have another problem you might be able to help with tho...

In forum PrusaSlicer

 před 4 years
He did. Thanks anyway 👍🏻

In forum PrusaSlicer

 před 4 years
In the start G-code. I didn’t think to look there 🤦‍♂️ Than...

In forum PrusaSlicer

 před 4 years
Can anyone help me with this? I still can’t figure out why t...

In forum PrusaSlicer

 před 4 years
Just seen my project hadn't uploaded. hopefully this time it...

In forum PrusaSlicer

 před 4 years
Bridge test.3mf

In forum PrusaSlicer

 před 4 years
Sorry. I'm using a creality ender 3 v2 and prusaslicer versi...

In forum PrusaSlicer

 před 4 years
Fan not disabling (newb help!)

In forum PrusaSlicer

 před 4 years
Thanks for the help guys. I’ll take a look at super slicer 👍...

In forum PrusaSlicer

 před 4 years
@neophyl Thanks for the reply neophyl. Surely if you can ch...

In forum PrusaSlicer

 před 4 years
Bridging Infill Settings

In forum PrusaSlicer

 před 4 years
Stránka 2 / 2
Share: