Notifications
Clear all
Graham666
Group: Registered
Joined: 2019/11/14
Active Member
1
|
I went into options as I was about to save the file as a 3mf... In forum PrusaSlicer |
5 years ago | |
|
@fuchsr Thanks for your quick reply. I saved it as a 3mf fil... In forum PrusaSlicer |
5 years ago | |
|
Radiused profiles generated as a series of flats In forum PrusaSlicer |
5 years ago | |
|
Blocked hotend In forum Hardware, firmware and software help |
5 years ago | |
| Thanks for the replies. | 6 years ago | |
| @joantabb Thanks Joan. | 6 years ago | |
| SD card not seen | 6 years ago | |
| @joantabb Thanks. | 6 years ago | |
| Fan value in tune section | 6 years ago | |
| @tim-m30 Thanks for the reply Tim. I checked everything but ... | 6 years ago | |
| Not completing Setup Wizard | 6 years ago |