Prusa3D Forum

Notifications

Clear all

glimps

Group: Registered

Joined: 2019/07/18

Active Member

	@bobstro It's not that I don't enjoy a bit of pre-release so... In forum PrusaSlicer	4 years ago
	Well thanks to this post I downloaded it using wget. It is s... In forum PrusaSlicer	4 years ago
	Figure it out! The hot end was mounted "lower" in the extrud... In forum Assembly and first prints troubleshooting	5 years ago
	Same thing happened here. Can someone at Prusa makes this cl... In forum Others (Archive)	5 years ago
	Thank you! Trying it right now, I'll come back with the resu... In forum Assembly and first prints troubleshooting	5 years ago
	I did the preflight check of the tie wrap distance. Should ... In forum Assembly and first prints troubleshooting	5 years ago
	First layer calibration fine, first print layer way too low In forum Assembly and first prints troubleshooting	5 years ago

Forum Statistics

565 Forums

63.9 K Topics

447.7 K Posts

19 Online

69.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed