Notifications
Clear all
Ginigraphy
Group: Registered
Joined: 2018/02/17
New Member
|
Hey thanks both of you!
I tried both, i checked the pinda p... In forum Hardware, firmware and software help |
7 years ago | |
|
Bed leveling fails on MK3 In forum Hardware, firmware and software help |
7 years ago | |
|
Firmware 3.1.2 RC1 adresses exactly this issue, see this thr... In forum Others (Archive) |
7 years ago | |
|
Won't print properly at layer height lower than 0.2mm In forum Others (Archive) |
7 years ago |