|
My heatbed started giving poor results yesterday, on a previ... En el foro Hardware, firmware and software help |
hace 8 years |
|
If the temperature drops really fast i would think there is ... En el foro Others (Archive) |
hace 8 years |
|
Agreed, gert is there a way to allow downloading a copy?
Im... En el foro Hardware, firmware and software help |
hace 8 years |
|
Made below excel, think it should be good, let me know other... En el foro Hardware, firmware and software help |
hace 8 years |
|
So 400 it should be:-)
Thanks
Ok, so the 3D printing needs ... En el foro Hardware, firmware and software help |
hace 8 years |
|
This looks very neat.
Just so i understand the math.
Inde... En el foro Hardware, firmware and software help |
hace 8 years |
|
Thanks Thomas.
Finger is on the order button. En el foro General discussion, announcements and releases |
hace 8 years |
|
MIni-Rambo 13 En el foro General discussion, announcements and releases |
hace 8 years |
|
Have you checked if you've received the $20 voucher mentione... En el foro General discussion, announcements and releases |
hace 8 years |
|
There is no bearings delivered in the Kit, old one for the x... En el foro Assembly and first prints troubleshooting |
hace 8 years |
|
I would think this is the final release? En el foro Hardware, firmware and software help |
hace 8 years |
|
Yes, I'm running the latest firmware.
As in 3.2.0 ? En el foro Hardware, firmware and software help |
hace 8 years |
|
Check if the thermistor have escaped from the tape under the... En el foro Hardware, firmware and software help |
hace 8 years |
|
Thanks Peter
I have been a bit lazy with removing the filam... En el foro General discussion, announcements and releases |
hace 8 years |
|
And do you what.
I don't have multimaterial device.
I poppe... En el foro General discussion, announcements and releases |
hace 8 years |
|
Peter
I usually always have some filament sitting loaded. W... En el foro General discussion, announcements and releases |
hace 8 years |
|
Unloading of filament. En el foro General discussion, announcements and releases |
hace 8 years |
|
Check if your pinda probe is to high. Refer to the building ... En el foro Others (Archive) |
hace 8 years |
|
When i had upgraded the hardware i installed 3.1.3, it was t... En el foro Hardware, firmware and software help |
hace 8 years |
|
Do you get the same problem if you print another model?
Hav... En el foro How do I print this? (Printing help) |
hace 8 years |
