|
So 400 it should be:-)
Thanks
Ok, so the 3D printing needs ... In forum Hardware, firmware and software help |
8 years ago |
|
This looks very neat.
Just so i understand the math.
Inde... In forum Hardware, firmware and software help |
8 years ago |
|
Thanks Thomas.
Finger is on the order button. In forum General discussion, announcements and releases |
8 years ago |
|
MIni-Rambo 13 In forum General discussion, announcements and releases |
8 years ago |
|
Have you checked if you've received the $20 voucher mentione... In forum General discussion, announcements and releases |
8 years ago |
|
There is no bearings delivered in the Kit, old one for the x... In forum Assembly and first prints troubleshooting |
8 years ago |
|
I would think this is the final release? In forum Hardware, firmware and software help |
8 years ago |
|
Yes, I'm running the latest firmware.
As in 3.2.0 ? In forum Hardware, firmware and software help |
8 years ago |
|
Check if the thermistor have escaped from the tape under the... In forum Hardware, firmware and software help |
8 years ago |
|
Thanks Peter
I have been a bit lazy with removing the filam... In forum General discussion, announcements and releases |
8 years ago |
|
And do you what.
I don't have multimaterial device.
I poppe... In forum General discussion, announcements and releases |
8 years ago |
|
Peter
I usually always have some filament sitting loaded. W... In forum General discussion, announcements and releases |
8 years ago |
|
Unloading of filament. In forum General discussion, announcements and releases |
8 years ago |
|
Check if your pinda probe is to high. Refer to the building ... In forum Others (Archive) |
8 years ago |
|
When i had upgraded the hardware i installed 3.1.3, it was t... In forum Hardware, firmware and software help |
8 years ago |
|
Do you get the same problem if you print another model?
Hav... In forum How do I print this? (Printing help) |
8 years ago |
|
Although you may find that the regular E3D heat break will w... In forum Hardware, firmware and software help |
8 years ago |
|
FYI In forum How do I print this? (Printing help) |
8 years ago |
|
I would think that a .25 nozzle is a bit fine for any filled... In forum How do I print this? (Printing help) |
8 years ago |
|
I calibrated the teh steps on my MK2S, moving to MK2.5 i hav... In forum General discussion, announcements and releases |
8 years ago |
