Prusa3D Forum

Notifications

Clear all

gcarmich

Group: Registered

Joined: 2016/11/08

Active Member

	Friction Coefficient and Hydroscopic Tendencies In forum General discussion, announcements and releases	8 months ago
	I swapped the data cable between extruders and pattern rever... In forum Assembly and first prints troubleshooting	11 months ago
	Nozel Heater Test failing on Extruder 1 - Initial Setup In forum Assembly and first prints troubleshooting	11 months ago
	Recommended Support Material Prusament PC In forum General discussion, announcements and releases	11 months ago
	Creality CR-10-V3 Print quality issues - Prusa Slicer In forum PrusaSlicer	3 years ago
	Success! Thank you! In forum PrusaSlicer	3 years ago
	Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3 In forum PrusaSlicer	3 years ago
	I just did the configuration wizard. I should be good now. ... In forum Hardware, firmware and software help	7 years ago
	I checked the printer setup and the build plate size is set ... In forum Hardware, firmware and software help	7 years ago
	I've been examining this issue that I originally reported. ... In forum Hardware, firmware and software help	7 years ago
	Object printing off center of plate In forum Hardware, firmware and software help	7 years ago
	i3 MK2 Z-axis issues after firmware upgrade In forum Others (Archive)	8 years ago

Forum Statistics

585 Forums

68.2 K Topics

477.5 K Posts

10 Online

75.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed