Prusa3D Forum

Notifications

Clear all

Gaius Pupus

Skupina: Registrovaný

Přidal se: 2024/01/19

Active Member

	I use extruder no. 5 for TPU printing and therefore I remove... In forum General discussion, announcements and releases	před 10 months
	I print up to 60A from Recreus with my TUP extension. Just d... In forum How do I print this? (Printing help)	před 10 months
	I have noticed that this TPU from Overture smears the nozzle... In forum How do I print this? (Printing help)	před 10 months
	Fiberlogy Fiberflex 40D does this job with the PTFE tubes fr... In forum How do I print this? (Printing help)	před 10 months
	The 3 PSU from the XL has more then enough power to supply t... In forum Hardware, firmware and software help	před 10 months
	Yes please make a "silence switch": All lights turning off (... In forum Prusa Connect & PrusaLink	před 11 months
	The friction from the PTFE tubes is too high, the filament i... In forum How do I print this? (Printing help)	před 1 year
	I have created another version with ball bearings: In forum How do I print this? (Printing help)	před 1 year
	quite mode switch In forum General discussion & User Experience & Ideas	před 1 year
	I have no place, to hang up a roll to the ceiling, so I made... In forum How do I print this? (Printing help)	před 2 years
	The Overture High-Speed TPU is a good suggestion, thank you.... In forum How do I print this? (Printing help)	před 2 years

Fórum Statistiky

595 Fóra

69 K Témata

482.8 K Příspěvky

19 Online

78 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed