Notifications
Clear all
gabriel
gabriel
Group: Registered
Joined: 2022/07/28
Active Member
1
Hi, Thanks for the feedback. Myself I have, for some time, a...

In forum Assembly and first prints troubleshooting

1 year ago
Interesting... indeed, there it is... I guess I never had to...

In forum Assembly and first prints troubleshooting

1 year ago
Here is another tip from Prusa support: re-route the ribbon ...

In forum Assembly and first prints troubleshooting

1 year ago
Hey there. I've been plagued by the screen blackout issue ev...

In forum Assembly and first prints troubleshooting

1 year ago
Hi, Here is my update. I have had this issue ever since I go...

In forum Assembly and first prints troubleshooting

1 year ago
Hi, I only print in PETG and PC-blend. The latter gives the ...

In forum Hardware, firmware and software help

1 year ago
Hey there, Thanks for sharing. As I said above, my MK4 is cu...

In forum Assembly and first prints troubleshooting

1 year ago
Mine did not do that. Mine was fine as the print was startin...

In forum Assembly and first prints troubleshooting

2 years ago
Thanks for the feedback. Possibly they ran out of replacemen...

In forum Assembly and first prints troubleshooting

2 years ago
Did you get a replacement printer? I was told that they will...

In forum Assembly and first prints troubleshooting

2 years ago
Yesterday I shipped back my MK4 for RMA. Fingers crossed.

In forum Assembly and first prints troubleshooting

2 years ago
In my case we suspect that the (factory assembled) printer w...

In forum Assembly and first prints troubleshooting

2 years ago
I have the same issue with my MK4. The LCD goes blank but th...

In forum Assembly and first prints troubleshooting

2 years ago
Hey there Dean, yeah I see molten plastic sticking to the be...

In forum Hardware, firmware and software help

2 years ago
Hi there, I just started using the MK4 yesterday and I see t...

In forum Hardware, firmware and software help

2 years ago
I should have updated my entry above. I thought that the NVD...

In forum PrusaSlicer

2 years ago
Hi there! This may help some of you out there. I was getting...

In forum PrusaSlicer

2 years ago
Share: