Notifications
Clear all
Fisherman
Fisherman
Group: Registered
Joined: 2020/08/14
Active Member
1
I had a chat with Prusa about this, when I ordered my conver...

In forum General discussion, announcements and releases

7 months ago
To be able to have the spool on the left, the dragchain must...

In forum General discussion, announcements and releases

10 months ago
Had both MMu2 and MMU3, not a single print failure yet on my...

In forum General discussion, announcements and releases

10 months ago
Are you serious? You want Prusa to pay you for your assembly...

In forum General discussion, announcements and releases

10 months ago
Hi,Could you please post a picture of the inside of your Sun...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
@joantab Thanks for your answer. I've reached a point now, ...

In forum General discussion, announcements and releases

5 years ago
Problems with first layer with multicolours-PETG

In forum General discussion, announcements and releases

5 years ago
Hi,Just a thought for the guys that just installed their fir...

In forum Assembly and first prints troubleshooting

5 years ago
@rythomas Hi,I'm not an expert at all, to me it looks good, ...

In forum Assembly and first prints troubleshooting

5 years ago
@bobstro Tried again, it does look a lot better, the surface...

In forum Assembly and first prints troubleshooting

5 years ago
@bobstro Thanks for your feedback and time on this. Will try...

In forum Assembly and first prints troubleshooting

5 years ago
Hi,I've included 3 versions of the Logo, unchanged, top laye...

In forum Assembly and first prints troubleshooting

5 years ago
Feedback on my print of Prusa Logo on newly assembled printe...

In forum Assembly and first prints troubleshooting

5 years ago
Hi, I'm new to 3d-printing, just finished building my 3Ks, b...

In forum Assembly and first prints troubleshooting

5 years ago
First and last layer issues

In forum Assembly and first prints troubleshooting

5 years ago
Share: