|
Ah the timing. I got home and found the shroud had fully bro... In forum Hardware, firmware and software help |
3 years ago |
|
I have been trying to avoid using nastier filaments. I think... In forum Hardware, firmware and software help |
3 years ago |
|
I haven't tried using a silicone sock yet. I'll get one, it'... In forum Hardware, firmware and software help |
3 years ago |
|
Melting/drooping fan shroud In forum Hardware, firmware and software help |
3 years ago |
|
@petar-i Your clear photo was very helpful to me also. Thank... In forum Hardware, firmware and software help |
3 years ago |
|
I'm in the same boat. I have a factory assembled mk3 (long s... In forum Hardware, firmware and software help |
3 years ago |
|
In the MMU2, this is handled in a pretty inconvenient way. E... In forum PrusaSlicer |
4 years ago |
|
@bobstro Thanks! It's not the behavior I would have expected... In forum How do I print this? (Printing help) |
4 years ago |
|
Minimum first layer height? In forum How do I print this? (Printing help) |
4 years ago |
|
On firmware 3.9.2.3524 "prusa3d_fw_MK3S_3_9_2_3524.hex" this... In forum General discussion, announcements and releases |
4 years ago |
|
I was trying to add printable pdf's for the Covid-19 prusa f... In forum General discussion, announcements and releases |
5 years ago |