Activity
 
Notifications
Clear all
Feday
Feday
Group: Registered
Joined: 2019/06/25
Active Member
1
Single wall imperfections

In forum How do I print this? (Printing help)

3 years ago
That totally makes sense, thanks! I suppose got confused by ...

In forum Hardware, firmware and software help

4 years ago
My prints are just fine in general. I'm experimenting with p...

In forum Hardware, firmware and software help

4 years ago
Flow rate is ignored from prusa

In forum Hardware, firmware and software help

4 years ago
Just leaving this here for the next person. PCTG prints fi...

In forum General discussion, announcements and releases

4 years ago
PCTG straight onto textured bed or not?

In forum General discussion, announcements and releases

4 years ago
Great, in the meantime I did keep getting errors about under...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Level my bed, or just trust auto level correction?

In forum Hardware, firmware and software help

5 years ago
I've replaced my heat break with the default one from E3d, e...

In forum Hardware, firmware and software help

5 years ago
So the replacement heat break (without 2.2mm->2.0mm ridge...

In forum Hardware, firmware and software help

6 years ago
Yes, do a cold pull after a jam, and then measure the fattes...

In forum Hardware, firmware and software help

6 years ago
Remember that if you have the MMU that the heat break us no...

In forum Hardware, firmware and software help

6 years ago
Yep, my shitty analog callipers say more then two mm...

In forum Hardware, firmware and software help

6 years ago
I'm having the exact same issue, I've also ordered a origina...

In forum Hardware, firmware and software help

6 years ago
I've connected a 3B (not a plus, but little difference) and ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Looks like things blocked up and the bowden gears just "sawe...

In forum Hardware, firmware and software help

6 years ago
Jams and under extrusion driving me crazy

In forum Hardware, firmware and software help

6 years ago
Share: