Notifications
Clear all
fatlazypig
Group: Registered
Joined: 2019/10/13
Active Member
1
|
PTFE tube collette damaged In forum Hardware, firmware and software help |
6 years ago | |
| so from what you can tell does it seem like I set it up corr... | 6 years ago | |
| octopi difficulties | 6 years ago | |
| recovering failed print | 6 years ago | |
| THANKYOU!! thankyou so much you guys. I was really getting f... | 6 years ago | |
| but seems not to be uniform, one corner or half the filamen... | 6 years ago | |
| best result I've achieved so far | 6 years ago | |
| Hello. so Im printing out 75x75mm squares and seem to be hav... | 6 years ago | |
| another 1st layer calibration picture the nozzle seems to dr... | 6 years ago | |
| Hi. thanks all. so I had another hotend clog. cleared this.... | 6 years ago | |
| Help | 6 years ago |