fabnavigator – Activité

Notifications

Clear all

fabnavigator

Groupe: Enregistré

A(ont) rejoint: 2020/10/17

Estimable Member

	There is some pretty interesting information in my original ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	It's been a while, so I can't say with 100% confidence, but ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Re-reading all of the above comments, there isn't anything t... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Is that 1mm when the filament is loaded? Dans le forum How do I print this? (Printing help)	il y a 4 years
	Unfortunately I can't recall what I did (I wish I kept bette... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese I would expect that if I had any of those poss... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@g-monkey There is definitely some consensus that retraction... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@swiss_cheese I did one test at 260C, 0.65mm outside perimet... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@swiss_cheese I'm glad you clarified that about spiral vase ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@swiss_cheese Thank you. That's some good information. I was... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@swiss_cheese Here it is. Attachment removed Dans le forum How do I print this? (Printing help)	il y a 5 years
	@swiss_cheese At this point it's just a small test structure... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@hawai Thank you for the comment, but that doesn't sound lik... Dans le forum How do I print this? (Printing help)	il y a 5 years
	In regard to item 3. above, upon closer examination I see a ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@bobstro The holes do not line up with the layer changes. Th... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Tiny holes in printed walls Dans le forum How do I print this? (Printing help)	il y a 5 years
	I've seen this, and adjusting live-z should help, but what I... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I did some more work on this. The "defects" might to be rela... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Thank you. Maybe someone else wil chime in. I have a few tho... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@joantabb Hi Joan, I have the seam position set to nearest. ... Dans le forum How do I print this? (Printing help)	il y a 5 years

Page 10 / 11 Précédent Suivant

Statistiques du forum

595 Forums

69 K Sujets

482.4 K Messages

14 En-ligne

77.7 K Membres

Le dernier des messages: Print Anomaly Notre nouveau membre: Hennadii Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé