eVenom – Activité – Prusa3D Forum

Notifications

Clear all

eVenom

Groupe: Enregistré

A(ont) rejoint: 2016/11/08

Estimable Member

	Tried the original file as is and it has the same issue in s... Dans le forum Print tips (Archive)	il y a 8 years
	How did they "FEEL"? Dans le forum Print tips (Archive)	il y a 8 years
	It's probably something with the model. I am not Familiar wi... Dans le forum Print tips (Archive)	il y a 8 years
	Those look fantastic! Did you fill them up with resin? if s... Dans le forum Print tips (Archive)	il y a 8 years
	It just finished printing and it came out fine. I used the d... Dans le forum Print tips (Archive)	il y a 8 years
	And that exactly what I meant. "I wish" as in "I wish it did... Dans le forum Print tips (Archive)	il y a 8 years
	I did and what's your point? Do you read that and take is as... Dans le forum Print tips (Archive)	il y a 8 years
	What slicer did you use? I want to try printing it using the... Dans le forum Print tips (Archive)	il y a 8 years
	Did you even read what I posted? I never said or implied sho... Dans le forum Print tips (Archive)	il y a 8 years
	I wish everyone that paid for S3d would instead donate to Sl... Dans le forum Print tips (Archive)	il y a 8 years
	I wish everyone that paid for S3d would instead donate to Sl... Dans le forum Print tips (Archive)	il y a 8 years
	Why use cura? Not bashing or hating. I just want to know wha... Dans le forum Print tips (Archive)	il y a 8 years
	Yeah, I am not sure what those lines are. Doesn't really loo... Dans le forum Print tips (Archive)	il y a 8 years
	The only adjustment I know of is on the other side where the... Dans le forum Print tips (Archive)	il y a 8 years
	looks like you got good results Dans le forum Print tips (Archive)	il y a 8 years
	1.1 is too much so if you need to go that high then there is... Dans le forum Print tips (Archive)	il y a 8 years
	Looks like is too far off the print bed Dans le forum Print tips (Archive)	il y a 8 years
	I have never used the Flow setting in the LCD but I mean in ... Dans le forum Print tips (Archive)	il y a 8 years
	Looks like underextrusion. try to raise the extrusion multip... Dans le forum Print tips (Archive)	il y a 8 years
	print the tree frog with the sd card gcode and if it works t... Dans le forum Print tips (Archive)	il y a 8 years

Page 4 / 6 Précédent Suivant

Statistiques du forum

565 Forums

64.1 K Sujets

449.2 K Messages

18 En-ligne

70.2 K Membres

Le dernier des messages: Prusa Core One - Intial thoughts...... Notre nouveau membre: shugobha Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé