Activity
 
Notifications
Clear all
Erik
Erik
Group: Registered
Joined: 2018/03/22
Eminent Member
2
Thanks for the response. I did end up printing them in resin...

In forum General discussion, announcements and releases

1 year ago
Resin for Mk4 upgrade parts?

In forum General discussion, announcements and releases

1 year ago
I’m having the same error. have you resolved?

In forum Hardware, firmware and software help

1 year ago
Sorry… In Regards To

In forum Hardware, firmware and software help

1 year ago
I agree with @neophyl on the draft shield and warping. I don...

In forum Hardware, firmware and software help

1 year ago
Multiple issues updating firmware to 3.13.0

In forum Hardware, firmware and software help

1 year ago
I've been printing through Octoprint without an sd card for ...

In forum Hardware, firmware and software help

1 year ago
Thanks; that's about what I thought, but I didn't know about...

In forum General discussion, announcements and releases

2 years ago
Agreed that z offset is too low. The built-in first layer ...

In forum General discussion, announcements and releases

2 years ago
Nozzle sizes and printer hardware setup question

In forum General discussion, announcements and releases

2 years ago
@hli Oooh, I hadn't thought of that... I have a pack of them...

In forum Hardware, firmware and software help

4 years ago
Yes, that was indeed the case. I was just composing a respon...

In forum Hardware, firmware and software help

4 years ago
Thank you for this. Yes, indeed, I have several instances of...

In forum Hardware, firmware and software help

4 years ago
My print fan has a mind of its own, and it's killing my high...

In forum Hardware, firmware and software help

4 years ago
PLEASE fix useless MMU2 error messages

In forum Hardware, firmware and software help

4 years ago
@protoncek It was a response to "I use powder coat, and it b...

In forum General discussion, announcements and releases

5 years ago
Just a quick note on terminology. "Powder coat" is a process...

In forum General discussion, announcements and releases

5 years ago
Can't help you with the layer shifts, but I have a terrible ...

In forum General discussion, announcements and releases

5 years ago
Yes, you are right; thank you for the correction. I'll edit ...

In forum General discussion, announcements and releases

5 years ago
There are a multitude of different contaminants that can fin...

In forum General discussion, announcements and releases

5 years ago
Page 1 / 2
Share: