Aktywność
 
Notifications
Clear all
epzcaw
epzcaw
Grupa: Zarejestrowany
Dołączył: 2019/10/15
Estimable Member
4
More confusion. Treefrog failed at 2.5mm with no discernible...

In forum General discussion, announcements and releases

5 years temu
RE: Multiple print failures

In forum General discussion, announcements and releases

5 years temu
Nothing is ever simple. I started printing "Buddy". It is...

In forum General discussion, announcements and releases

5 years temu
@zoltan No, I believe the right hand is the set temperature ...

In forum General discussion, announcements and releases

5 years temu
I didn't actually observe the temperature change on the Prus...

In forum General discussion, announcements and releases

5 years temu
RE: Multiple print failures

In forum General discussion, announcements and releases

5 years temu
RE: Multiple print failures

In forum General discussion, announcements and releases

5 years temu
RE: Multiple print failures

In forum General discussion, announcements and releases

5 years temu
I greatly appreciate all the support and advice offered here...

In forum General discussion, announcements and releases

5 years temu
Today I printed three of model Mk3_Buddy_150um successfully....

In forum General discussion, announcements and releases

5 years temu
I do have a Raspberry Pi, but have done only a limited amoun...

In forum General discussion, announcements and releases

5 years temu
Am now running the Buddy model. But since the treefrog (50um...

In forum General discussion, announcements and releases

5 years temu
@zoltan Thanks for that. But at the moment, I can't print a...

In forum General discussion, announcements and releases

5 years temu
@zoltan Re .05 layers - they may be an issue but the failure...

In forum General discussion, announcements and releases

5 years temu
RE: Multiple print failures

In forum General discussion, announcements and releases

5 years temu
The nozzle temperature was within one degree of the specifie...

In forum General discussion, announcements and releases

5 years temu
Alas, I am back. More print failures and spool jamming is n...

In forum General discussion, announcements and releases

5 years temu
I don't think the problem is solved. Tim's suggestion re fi...

In forum General discussion, announcements and releases

5 years temu
I ran the same model but at .2mm layer thickness (to save ti...

In forum General discussion, announcements and releases

5 years temu
I left it printing at midnight, and came down this morning t...

In forum General discussion, announcements and releases

5 years temu
Strona 3 / 6
Share: