|
Thanks both. Yes, I think if this kind of thing happens agai... In forum Hardware, firmware and software help |
4 years ago |
|
The first 8 hour print was perfect, and the first of the rem... In forum Hardware, firmware and software help |
4 years ago |
|
I fitted the new thermistor, updated the firmware and ran th... In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v Sorry I was thinking of the heating element, not th... In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v No problem! I did try testing at the wires next to ... In forum Hardware, firmware and software help |
4 years ago |
|
Ok so I poked the meter wires into the plug - open circuit, ... In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v Ok so I just checked the fuses - all OK. Checked al... In forum Hardware, firmware and software help |
4 years ago |
|
Just for completeness - I ran a 16 hour job yesterday, overn... In forum Hardware, firmware and software help |
4 years ago |
|
And also just to say, when I switch the machine on, the serv... In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v Yes, also, when it failed, it didn't fail and retur... In forum Hardware, firmware and software help |
4 years ago |
|
@joantabb Thanks Joan. Actually, something's wrong there - Y... In forum Hardware, firmware and software help |
4 years ago |
|
@karl-herbert Thank you. Based on that, and Milos's tests, I... In forum Hardware, firmware and software help |
4 years ago |
|
Ok so I measured with the sensor in my hands - about 70 K Oh... In forum Hardware, firmware and software help |
4 years ago |
|
SORRY! I made a mistake with a plug! The ambients (nominals)... In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v And yes, I disconnected and measured from the pins. In forum Hardware, firmware and software help |
4 years ago |
|
@milos-v Thanks, The bed nominal temperature is high (28 deg... In forum Hardware, firmware and software help |
4 years ago |
|
The thermistor came out of the head quite easily - the grubs... In forum Hardware, firmware and software help |
4 years ago |
|
I just checked both thermistors (bed and nozzle, and they bo... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks Milos. In forum Hardware, firmware and software help |
4 years ago |
|
The strange thing is, according to the Prusa info: "Thermal ... In forum Hardware, firmware and software help |
4 years ago |
