Prusa3D Forum

Notifications

Clear all

dkaustin

Group: Registered

Joined: 2016/12/16

Active Member

	OK, I've spent some time looking at the failed prints, and h... In forum General discussion, announcements and releases	1 month ago
	MK4S Always Fails at Same Point in Print, "Stuck Filament" In forum General discussion, announcements and releases	1 month ago
	Is This Pinda2 Working or Not? In forum Hardware, firmware and software help	2 years ago
	Cannot Enter Custom Gcode in Prusaslicer 2.2.0 In forum PrusaSlicer	4 years ago
	Which IP address? From my experience it can cope only with 1... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	Is the FlashAir card getting a DHCP lease from your router? ... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	I've spent two days trying to set up the FlashAir and cannot... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	ian.c16 reported that he read on Reddit that his week 9 blac... In forum General discussion, announcements and releases	6 years ago
	Week 9 black kit with powder coated sheet. I've waited this... In forum General discussion, announcements and releases	6 years ago

Forum Statistics

559 Forums

63.1 K Topics

443.8 K Posts

20 Online

68 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed