david.b14 – Activité – Prusa3D Forum

Notifications

Clear all

david.b14

Groupe: Enregistré

A(ont) rejoint: 2016/10/31

Honorable Member

	Easy / Cheap way to add tensile strength to PLA print. Dans le forum Print tips (Archive)	il y a 8 years
	That is a good point. For really tall prints, I could put a... Dans le forum Print tips (Archive)	il y a 8 years
	I thought this may be of interest for those running UPS. Th... Dans le forum Improvements (Archive)	il y a 8 years
	I thought this may be of interest for those running UPS. Th... Dans le forum Improvements (Archive)	il y a 8 years
	I plan on using a $20 PC power supply like this one: Out... Dans le forum Improvements (Archive)	il y a 8 years
	Any issue with using lube on the threaded z-axis rods? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Will adding an ooze shield be benificial when printing with ... Dans le forum Print tips (Archive)	il y a 8 years
	Printing spare parts - Can I get away with some parts in PLA... Dans le forum Others (Archive)	il y a 8 years
	Dedicated power for heater bed. Dans le forum Improvements (Archive)	il y a 8 years
	I found on this forum that a 32gig card is okay, updating th... Dans le forum Ostatní (Archiv)	il y a 8 years
	Considering upgrading the heater bed connection to Rambo boa... Dans le forum Improvements (Archive)	il y a 8 years
	I ran across this: New feature: Bed leveling adjustment at ... Dans le forum Others (Archive)	il y a 8 years
	If I put a solid state relay on the wires going to the heate... Dans le forum Improvements (Archive)	il y a 8 years
	Please post your UPS brand and model if using it for the MK2... Dans le forum Improvements (Archive)	il y a 8 years
	GCode G80 command for fine-tuning Dans le forum Others (Archive)	il y a 8 years
	I'm not sure why I didn't think of this before, but I have a... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Some of my prints run 24 hrs which rules out humans. In thi... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I agree. One could make a 3D print of a box with two chambe... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Another possible DYI solution is to use baking soda and vine... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Also, this would do the trick but would be super messy: I... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 29 / 30 Précédent Suivant

Statistiques du forum

565 Forums

63.4 K Sujets

445.4 K Messages

20 En-ligne

68.5 K Membres

Le dernier des messages: print fan is not spinning error Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé