Notifications
Clear all
CUKIO34
Group: Registered
Joined: 2024/04/26
Active Member
1
|
I like others have been having this issue. Customer service ... In forum Hardware, firmware and software help |
6 days ago | |
| im having a similar issue where my second layer in tool head... | 1 month ago | |
| Im using a generic PLA. I swapped the entire heater block ou... | 1 month ago | |
| Extruder not working on 2nd layer and up for tool head one | 2 months ago | |
|
Thank you for the link . Just what I needed. In forum Hardware, firmware and software help |
3 months ago | |
|
It may have been originally. But I put in a new nozzle and i... In forum Hardware, firmware and software help |
3 months ago | |
|
Filament wont load In forum Hardware, firmware and software help |
3 months ago | |
|
RBI KING_3D Attached the .3mf. I dont think its the temper... In forum PrusaSlicer |
8 months ago | |
|
*prusa slicer In forum PrusaSlicer |
8 months ago | |
|
Bridge overlap is not catching In forum PrusaSlicer |
8 months ago | |
|
prusa slicer 2.7.4 freezes on infill In forum PrusaSlicer |
9 months ago |