Notifiche
Cancella tutti
cristian.s
cristian.s
Gruppo: Registrato
Registrato: 2016/05/31
Trusted Member
3
Printing a replacement extruder body

Nel forum Others (Archive)

8 years fa
Hi, Looks like the copper plated e3d heater block is no lon...

Nel forum Others (Archive)

8 years fa
I have this problem as well. It also adds blobs of material ...

Nel forum Others (Archive)

8 years fa
James, you said you attached your updated file to a comment ...

Nel forum Improvements (Archive)

8 years fa
OK, sarcasm. This is the printer I was talking about: It's ...

Nel forum Improvements (Archive)

8 years fa
Me too! Will not be using Loctite again on the PINDA probe.....

Nel forum Assembly and first prints troubleshooting

8 years fa
Print failure detection

Nel forum Improvements (Archive)

8 years fa
Swappable extruder cores

Nel forum Improvements (Archive)

8 years fa
Josef keeps hinting at a multi material hotend upgrade

Nel forum Improvements (Archive)

8 years fa
Nice review of the MK2

Nel forum Others (Archive)

8 years fa
Yes, sure. They haven't sent anything yet, however...

Nel forum General discussion, announcements and releases

8 years fa
Got a message from Simplify3D support asking me if I would b...

Nel forum General discussion, announcements and releases

8 years fa
I received a helpful response on August 9th from S3D on the ...

Nel forum General discussion, announcements and releases

8 years fa
For the record I used those g-codes several times without an...

Nel forum General discussion, announcements and releases

8 years fa
Oops. OK, that makes sense :). Thanks L.E. Funny story, I ...

Nel forum General discussion, announcements and releases

8 years fa
I was looking at the pre-sliced Adalinda g-code that comes w...

Nel forum General discussion, announcements and releases

8 years fa
Yes, I got something similar from them. They said they are n...

Nel forum General discussion, announcements and releases

8 years fa
I just posted a support ticket asking them if they will offi...

Nel forum General discussion, announcements and releases

8 years fa
Has anyone tried Magigoo?

Nel forum Improvements (Archive)

8 years fa
I printed 3Dbenchy instead and it seems that retraction is n...

Nel forum General discussion, announcements and releases

8 years fa
Pagina 2 / 4
Condividi: