|
Printing a replacement extruder body In forum Others (Archive) |
8 years ago |
|
Hi,
Looks like the copper plated e3d heater block is no lon... In forum Others (Archive) |
8 years ago |
|
I have this problem as well.
It also adds blobs of material ... In forum Others (Archive) |
8 years ago |
|
James, you said you attached your updated file to a comment ... In forum Improvements (Archive) |
8 years ago |
|
OK, sarcasm.
This is the printer I was talking about:
It's ... In forum Improvements (Archive) |
8 years ago |
|
Me too!
Will not be using Loctite again on the PINDA probe..... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Print failure detection In forum Improvements (Archive) |
8 years ago |
|
Swappable extruder cores In forum Improvements (Archive) |
8 years ago |
|
Josef keeps hinting at a multi material hotend upgrade In forum Improvements (Archive) |
8 years ago |
|
Nice review of the MK2 In forum Others (Archive) |
8 years ago |
|
Yes, sure. They haven't sent anything yet, however... In forum General discussion, announcements and releases |
8 years ago |
|
Got a message from Simplify3D support asking me if I would b... In forum General discussion, announcements and releases |
8 years ago |
|
I received a helpful response on August 9th from S3D on the ... In forum General discussion, announcements and releases |
8 years ago |
|
For the record I used those g-codes several times without an... In forum General discussion, announcements and releases |
8 years ago |
|
Oops.
OK, that makes sense :).
Thanks
L.E.
Funny story, I ... In forum General discussion, announcements and releases |
8 years ago |
|
I was looking at the pre-sliced Adalinda g-code that comes w... In forum General discussion, announcements and releases |
8 years ago |
|
Yes, I got something similar from them.
They said they are n... In forum General discussion, announcements and releases |
8 years ago |
|
I just posted a support ticket asking them if they will offi... In forum General discussion, announcements and releases |
8 years ago |
|
Has anyone tried Magigoo? In forum Improvements (Archive) |
8 years ago |
|
I printed 3Dbenchy instead and it seems that retraction is n... In forum General discussion, announcements and releases |
8 years ago |
