|
Printing a replacement extruder body Im Forum Others (Archive) |
Vor 9 years |
|
Hi,
Looks like the copper plated e3d heater block is no lon... Im Forum Others (Archive) |
Vor 9 years |
|
I have this problem as well.
It also adds blobs of material ... Im Forum Others (Archive) |
Vor 9 years |
|
James, you said you attached your updated file to a comment ... Im Forum Improvements (Archive) |
Vor 9 years |
|
OK, sarcasm.
This is the printer I was talking about:
It's ... Im Forum Improvements (Archive) |
Vor 9 years |
|
Me too!
Will not be using Loctite again on the PINDA probe..... Im Forum Assembly and first prints troubleshooting |
Vor 9 years |
|
Print failure detection Im Forum Improvements (Archive) |
Vor 9 years |
|
Swappable extruder cores Im Forum Improvements (Archive) |
Vor 9 years |
|
Josef keeps hinting at a multi material hotend upgrade Im Forum Improvements (Archive) |
Vor 10 years |
|
Nice review of the MK2 Im Forum Others (Archive) |
Vor 10 years |
|
Yes, sure. They haven't sent anything yet, however... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
Got a message from Simplify3D support asking me if I would b... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
I received a helpful response on August 9th from S3D on the ... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
For the record I used those g-codes several times without an... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
Oops.
OK, that makes sense :).
Thanks
L.E.
Funny story, I ... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
I was looking at the pre-sliced Adalinda g-code that comes w... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
Yes, I got something similar from them.
They said they are n... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
I just posted a support ticket asking them if they will offi... Im Forum General discussion, announcements and releases |
Vor 10 years |
|
Has anyone tried Magigoo? Im Forum Improvements (Archive) |
Vor 10 years |
|
I printed 3Dbenchy instead and it seems that retraction is n... Im Forum General discussion, announcements and releases |
Vor 10 years |
