|
Try this setting. Worked for me. With and without MMU. Let m... En el foro Hardware, firmware and software help |
hace 10 months |
|
I've seen this issue with Colorfabb and Eryone PLA, printing... En el foro Hardware, firmware and software help |
hace 2 years |
|
printer or MMU2S is scraping off filament En el foro Hardware, firmware and software help |
hace 2 years |
|
Is this sound ok ? 🙂 En el foro Hardware, firmware and software help |
hace 2 years |
|
Nope, still curling edges. Going to apply the nyloc nut mod.... En el foro Hardware, firmware and software help |
hace 3 years |
|
Yes, corners look terrible, Rippled and way too low nozzle. En el foro Hardware, firmware and software help |
hace 3 years |
|
I will give it a try tomorrow! tnx again En el foro Hardware, firmware and software help |
hace 3 years |
|
thats the point, how ? just by lowering the nozzle with live... En el foro Hardware, firmware and software help |
hace 3 years |
|
@diem Issue is still there :(What can I do next ? En el foro Hardware, firmware and software help |
hace 3 years |
|
Will try tomorrow. Tnx Diem En el foro Hardware, firmware and software help |
hace 3 years |
|
I've bought this printer, just to not have to modify it, its... En el foro Hardware, firmware and software help |
hace 3 years |
|
After another calibration session, the print improved a lot,... En el foro Hardware, firmware and software help |
hace 3 years |
|
I received this printer in January, Fully assembled.Had to r... En el foro Hardware, firmware and software help |
hace 3 years |
|
did some more tests, tried another sheet, no difference. Whe... En el foro Hardware, firmware and software help |
hace 3 years |
|
Tnx Diem, I've tried that. Even with the 7x7 mesh bed level... En el foro Hardware, firmware and software help |
hace 3 years |
|
Btw, I've checked if there was anything under the steel shee... En el foro Hardware, firmware and software help |
hace 3 years |
|
Bed curved ? En el foro Hardware, firmware and software help |
hace 3 years |
|
Not sure wat happened, After I turned the pi off and back on... En el foro Bugs & Errors |
hace 3 years |
|
Missing info at settings screen En el foro Bugs & Errors |
hace 3 years |
|
Large blob on wipe tower En el foro Hardware, firmware and software help |
hace 3 years |
