|
Try this setting. Worked for me. With and without MMU. Let m... In forum Hardware, firmware and software help |
8 months ago |
|
I've seen this issue with Colorfabb and Eryone PLA, printing... In forum Hardware, firmware and software help |
2 years ago |
|
printer or MMU2S is scraping off filament In forum Hardware, firmware and software help |
2 years ago |
|
Is this sound ok ? 🙂 In forum Hardware, firmware and software help |
2 years ago |
|
Nope, still curling edges. Going to apply the nyloc nut mod.... In forum Hardware, firmware and software help |
3 years ago |
|
Yes, corners look terrible, Rippled and way too low nozzle. In forum Hardware, firmware and software help |
3 years ago |
|
I will give it a try tomorrow! tnx again In forum Hardware, firmware and software help |
3 years ago |
|
thats the point, how ? just by lowering the nozzle with live... In forum Hardware, firmware and software help |
3 years ago |
|
@diem Issue is still there :(What can I do next ? In forum Hardware, firmware and software help |
3 years ago |
|
Will try tomorrow. Tnx Diem In forum Hardware, firmware and software help |
3 years ago |
|
I've bought this printer, just to not have to modify it, its... In forum Hardware, firmware and software help |
3 years ago |
|
After another calibration session, the print improved a lot,... In forum Hardware, firmware and software help |
3 years ago |
|
I received this printer in January, Fully assembled.Had to r... In forum Hardware, firmware and software help |
3 years ago |
|
did some more tests, tried another sheet, no difference. Whe... In forum Hardware, firmware and software help |
3 years ago |
|
Tnx Diem, I've tried that. Even with the 7x7 mesh bed level... In forum Hardware, firmware and software help |
3 years ago |
|
Btw, I've checked if there was anything under the steel shee... In forum Hardware, firmware and software help |
3 years ago |
|
Bed curved ? In forum Hardware, firmware and software help |
3 years ago |
|
Not sure wat happened, After I turned the pi off and back on... In forum Bugs & Errors |
3 years ago |
|
Missing info at settings screen In forum Bugs & Errors |
3 years ago |
|
Large blob on wipe tower In forum Hardware, firmware and software help |
3 years ago |
