Prusa3D Forum

Notifications

Clear all

ColinTD

Group: PreRegistered

Joined: 2023/06/07

Title: Member

	I've just had very similar issue: near perfect first layer, ... In forum Assembly and first prints troubleshooting	12 months ago
	No complaint was intended! The remote printing support is g... In forum Introduction & Instructions	2 years ago
	Fyi, I've just swapped out the official RPi Cam V3, for an o... In forum Introduction & Instructions	2 years ago
	I've just done a fresh install of the latest 0.7.0 PrusaLink... In forum Introduction & Instructions	2 years ago

Forum Statistics

565 Forums

64.1 K Topics

448.9 K Posts

18 Online

70.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed