Benachrichtigungen
Alles löschen
christopher.d16
christopher.d16
Gruppe: Registriert
Beigetreten: 2018/04/23
Eminent Member
2
I'm always very careful to have all of the parts on the same...

Im Forum How do I print this? (Printing help)

Vor 6 years
Not all parts in model printing?

Im Forum How do I print this? (Printing help)

Vor 6 years
I tried holding out for the powder coated sheet but gave up....

Im Forum General discussion, announcements and releases

Vor 6 years
You might want to run through this routine to make sure your...

Im Forum General discussion, announcements and releases

Vor 6 years
I would try drying the filament and make sure you store it i...

Im Forum How do I print this? (Printing help)

Vor 6 years
That's a good idea...I'm going to give that a try. Works we...

Im Forum General discussion, announcements and releases

Vor 6 years
Hi Robin....I'm not sure I'm following you. I also use Slic...

Im Forum General discussion, announcements and releases

Vor 6 years
So far I've printed some small parts on this surface....noth...

Im Forum General discussion, announcements and releases

Vor 6 years
Yeah durability seems like it could be an issue...not sure h...

Im Forum General discussion, announcements and releases

Vor 6 years
Yes...I had to add +0.15 Z-offset to my nylon profile to get...

Im Forum General discussion, announcements and releases

Vor 6 years
Well...so far all I have had time to do is run a few test pr...

Im Forum General discussion, announcements and releases

Vor 6 years
So after a few test prints it was easy to dial in the Z-heig...

Im Forum General discussion, announcements and releases

Vor 6 years
Hi Kevin...I have the new plate and the print surface is ins...

Im Forum General discussion, announcements and releases

Vor 6 years
I use sealable pet food containers for some rolls and large ...

Im Forum General discussion, announcements and releases

Vor 6 years
Compensating for different build plate thicknesses?

Im Forum General discussion, announcements and releases

Vor 6 years
As Phil mentioned above...maybe try adjusting your live Z wi...

Im Forum General discussion, announcements and releases

Vor 6 years
Allen...thank you for the feedback. I had good success with...

Im Forum General discussion, announcements and releases

Vor 6 years
Well...I ordered the bare BuildTak plate and the new roll of...

Im Forum General discussion, announcements and releases

Vor 6 years
I've had a great experience with the MK3 also...it's a very ...

Im Forum General discussion, announcements and releases

Vor 6 years
GeckoTek EZ-Stik surface on flexplate for nylon?

Im Forum General discussion, announcements and releases

Vor 6 years
Seite 1 / 2
Teilen: