Notifications
Clear all
ChristianWagner
Group: Registered
Joined: 2016/12/18
Active Member
1
|
Okay, it turned out that my filament spool was too tight in ... In forum Others (Archive) |
8 years ago | |
|
filament powder on motors In forum Others (Archive) |
8 years ago | |
|
Ok so I switched over to orange filament and it did really w... In forum Others (Archive) |
8 years ago | |
|
(Btw I have reset the printer a few times so when I was at -... In forum Others (Archive) |
8 years ago | |
|
As for v2calibration when it is at 0.000 it is basically hit... In forum Others (Archive) |
8 years ago | |
|
Ok, atm i can only answer/do a few of these, but ill do the ... In forum Others (Archive) |
8 years ago | |
|
Pictures here In forum Others (Archive) |
8 years ago | |
|
Cannot get a good first layer In forum Others (Archive) |
8 years ago |