Notifications
Clear all
chris.p8
chris.p8
Group: Registered
Joined: 2017/02/08
Trusted Member
3
Did you post a bug? I am now worried that my nice new print...

In forum Hardware, firmware and software help

7 years ago
Yes, I had a similar response but when I pressed them they s...

In forum Others (Archive)

7 years ago
Try a pre-heat first, to warm things up - then press the 'X ...

In forum Others (Archive)

7 years ago
When you open an STL file and generate the gcode, is it poss...

In forum Hardware, firmware and software help

7 years ago
No problem at all - worth trying everything and I have learn...

In forum Prusa i3 kit (Archive)

7 years ago
I have now replaced the heater cables but this did not make ...

In forum Prusa i3 kit (Archive)

7 years ago
Ok, I guess that's a fairly simple task, and will rule that ...

In forum Prusa i3 kit (Archive)

7 years ago
Measured 12.7 v at the Rambo socket and 12.5 v at the heat b...

In forum Prusa i3 kit (Archive)

7 years ago
Including the extruder parts? I was told PLA would deform w...

In forum Prusa i3 kit (Archive)

7 years ago
Thank you Joan and Peter (and everyone else!) Next I am goi...

In forum Prusa i3 kit (Archive)

7 years ago
Looks like my connector in the Rambo is fine - I ran the hea...

In forum Prusa i3 kit (Archive)

7 years ago
After damaging my PEI sheet pulling a print off, I invested ...

In forum Prusa i3 kit (Archive)

7 years ago
Yes, I take your point - I have had the connector in and out...

In forum Prusa i3 kit (Archive)

7 years ago
Thanks for this - I did wonder about this, but have been usi...

In forum Prusa i3 kit (Archive)

7 years ago
Thanks, I tried that and it is better but I still get the od...

In forum Prusa i3 kit (Archive)

7 years ago
Print bed issues....

In forum Prusa i3 kit (Archive)

7 years ago
If you are measuring the thickness of the film using a micro...

In forum Assembly and first prints troubleshooting

7 years ago
I was printing away on Sunday on my MK2S and the printer sud...

In forum Others (Archive)

7 years ago
After some experimentation it would seem that there is a big...

In forum Hardware, firmware and software help

7 years ago
Correction... "When I do find a file and select it to print...

In forum Software (Archive)

7 years ago
Page 3 / 5
Share: