Notifications
Clear all
chris.p37
Skupina: Registrovaný
Přidal se: 2019/04/07
Active Member
1
| Thanks for this. | před 6 years | |
| Are you saying you should run a 12V heater with the 24V syst... | před 6 years | |
| My Mk3s printer has a 24v power supply, i thought that was o... | před 6 years | |
| Why does it specify the 24V for the MK3s? | před 6 years | |
| The 24V 40W heater was specified for the Mk3s printer? | před 6 years | |
| Joan, Hi Joan, I ordered the 24V 40W hotend heater cartrid... | před 6 years | |
| I've just ordered a new heater and thermistor if all else fa... | před 6 years | |
| Thanks Joan, The print is using nearly all of the X Axis so ... | před 6 years | |
| OK, i'll have a look thanks. | před 6 years | |
| I did think of that! I've tried looking for anything obvious... | před 6 years | |
| I did think of that!. I've tried looking for anything obviou... | před 6 years | |
| Thermal Runaway | před 6 years |