Notifications
Clear all
chris.b47
Group: Registered
Joined: 2018/06/13
Active Member
1
| I installed the plugin, but it is not outputting the heatmap... | 7 years ago | |
| Do I have to manually install matplotlib and numpy beforehan... | 7 years ago | |
| Octoprint Bed Visualizer G-Code | 7 years ago | |
| I had to make shims and place them under the bushings on my ... | 7 years ago | |
|
Slic3r Custom Layer Settings? In forum Hardware, firmware and software help |
7 years ago | |
| Inconsistent First Layer Calibration | 7 years ago | |
|
Meshmixer Profile for MK3? In forum Hardware, firmware and software help |
7 years ago | |
| Nylon and soft materials, if possible. | 7 years ago | |
| Will you have additional material profiles as they are avail... | 7 years ago | |
|
Setting up Slic3r and Cura In forum Hardware, firmware and software help |
7 years ago |