Notifications
Clear all
chking
Skupina: Registrovaný
Přidal se: 2023/01/05
Active Member
1
|
This is really frustrating not being able to send a gcode co... In forum Introduction & Instructions |
před 6 months | |
| Filament can't get past the BondTech gears | před 2 years | |
| I ended up using super glue to hold the sleeves in. | před 2 years | |
| Copper sleeves slide out | před 2 years | |
| Why aren't there more 3D printable models for the awards? I... | před 2 years | |
|
Filament settings In forum PrusaSlicer |
před 3 years |