Notifications
Clear all
chking
Group: Registered
Joined: 2023/01/05
Active Member
1
|
This is really frustrating not being able to send a gcode co... In forum Introduction & Instructions |
5 months ago | |
| Filament can't get past the BondTech gears | 2 years ago | |
| I ended up using super glue to hold the sleeves in. | 2 years ago | |
| Copper sleeves slide out | 2 years ago | |
| Why aren't there more 3D printable models for the awards? I... | 2 years ago | |
|
Filament settings In forum PrusaSlicer |
3 years ago |