Aktivität
 
Benachrichtigungen
Alles löschen
CH
CH
Gruppe: Registriert
Beigetreten: 2018/01/09
Eminent Member
2
@dan-p12 Thanks for your effort, much appreciated! Tried to ...

Im Forum How do I print this? (Printing help)

Vor 4 years
@bobstro Thanks, that confirms my suspicions. Printing with ...

Im Forum How do I print this? (Printing help)

Vor 4 years
Ned some help on printing PETG with fillets

Im Forum How do I print this? (Printing help)

Vor 4 years
Ok, about time to stop using acetone all the time!! Thank yo...

Im Forum Hardware, firmware and software help

Vor 6 years
Aha... no more Windex and PLA then 🙂 Does this mean I shou...

Im Forum Hardware, firmware and software help

Vor 6 years
Acetone as primary cleaner?

Im Forum Hardware, firmware and software help

Vor 6 years
Good to hear I'm not alone 😉 Are you going slower for the...

Im Forum How do I print this? (Printing help)

Vor 6 years
Problem printing Dart Vader with supports

Im Forum How do I print this? (Printing help)

Vor 6 years
Been busy lately so have not not had the time to either prin...

Im Forum Hardware, firmware and software help

Vor 7 years
Thanks! good to know the source of the problem! Do you (or a...

Im Forum Hardware, firmware and software help

Vor 7 years
You mean that the nozzle is touching the infill? I have not...

Im Forum Hardware, firmware and software help

Vor 7 years
Bad noise from Y carriage

Im Forum Hardware, firmware and software help

Vor 7 years
About the PSU vibration noise

Im Forum Hardware, firmware and software help

Vor 7 years
Ok, that was reassuring 🙂 I'll heat up the bed a few times ...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Steel sheet got blisters after printing!

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Great! I was just about to post more about this noise. The c...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Update: Ok, this seems to have done the trick. I got some f...

Im Forum How do I print this? (Printing help)

Vor 7 years
Just want to clear this up. It was most probably the fast an...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Thanks! As I started the print I'm doing now I was thinkin...

Im Forum How do I print this? (Printing help)

Vor 7 years
Could be, but the tests says everything is fine. Is it possi...

Im Forum How do I print this? (Printing help)

Vor 7 years
Seite 1 / 2
Teilen: