Čeština
Fóra
Uživatelé
CellarDoor
Aktivita
 
Notifications
Clear all
CellarDoor
CellarDoor
Skupina: Registrovaný
Přidal se: 2017/07/05
Eminent Member
2
Profile Aktivita
Uh, that actually is a powder coated sheet - but a prototype...

In forum Assembly and first prints troubleshooting

 před 6 years
Calibrate first layer with ABS

In forum How do I print this? (Printing help)

 před 6 years
Optimizing print quality

In forum Assembly and first prints troubleshooting

 před 6 years
So I ordered a new hotend and it arrived last week. Until th...

In forum Prusa i3 kit (Archive)

 před 7 years
Yes, I feared that, though the hotend is only a few moths in...

In forum Prusa i3 kit (Archive)

 před 7 years
Here's a quick shot of what I end up having trouble with (de...

In forum Prusa i3 kit (Archive)

 před 7 years
Oh I didn't try to use the hotend without nozzle (that's wha...

In forum Prusa i3 kit (Archive)

 před 7 years
So I worked for two days straight on the problem and i can't...

In forum Prusa i3 kit (Archive)

 před 7 years
Extruision Problems

In forum Prusa i3 kit (Archive)

 před 7 years
Problems with fine details

In forum Prusa i3 kit (Archive)

 před 7 years
Today I reprinted the part – the fan nozzle fits perfectly :...

In forum Prusa i3 kit (Archive)

 před 7 years
I tried to glue it today, but it's relly just the one small ...

In forum Prusa i3 kit (Archive)

 před 7 years
Sounds good, thanks 🙂 Though it's mainly a small part aroun...

In forum Prusa i3 kit (Archive)

 před 7 years
Fan Nozzle broke loose

In forum Prusa i3 kit (Archive)

 před 7 years
I carefully went through the points in the mentioned thread ...

In forum Others (Archive)

 před 7 years
Thanks for your replies; of course I am sure they are avoida...

In forum Others (Archive)

 před 7 years
Hm, mashed up hotend

In forum Others (Archive)

 před 7 years
Quite a problem

In forum Others (Archive)

 před 7 years
Stránka 2 / 2
Share: