Notifications
Clear all
CaptainKiwii
CaptainKiwii
Group: Registered
Joined: 2018/02/12
Active Member
1
Hola, did you ever found an issue @hooch?

In forum General discussion, announcements and releases

1 year ago
Ok so i finally successfully change all of this... thanks to...

In forum Hardware, firmware and software help

5 years ago
Ok so i'm starting to get mad about all of this, it's seriou...

In forum Hardware, firmware and software help

5 years ago
That's a good question, it clearly lack information on the p...

In forum Hardware, firmware and software help

5 years ago
is that the same? For all I can say for now(since i can't ...

In forum Hardware, firmware and software help

5 years ago
I didn't built the printer, it was a prebuilt ^^ The piece t...

In forum Hardware, firmware and software help

5 years ago
Hi, thanks for your time. I though about that but the heat b...

In forum Hardware, firmware and software help

5 years ago
[Hardware] Temp Probe to change, screw on the heat block fuc...

In forum Hardware, firmware and software help

5 years ago
Any Idea any one?

In forum Assembly and first prints troubleshooting

6 years ago
Did it solved your issue?

In forum Others (Archive)

6 years ago
Ok so, I can print things now, but at mini 0.2 mm layer (und...

In forum Assembly and first prints troubleshooting

7 years ago
Well when I performe the calibration, it runs fine once cali...

In forum Assembly and first prints troubleshooting

7 years ago
I'll give it another go tonight before looking for flashing...

In forum Assembly and first prints troubleshooting

7 years ago
If you need to adjust the Z level at each print, "First laye...

In forum Assembly and first prints troubleshooting

7 years ago
Hi; thanks for taking the time. Here's another link : Th...

In forum Assembly and first prints troubleshooting

7 years ago
@martin.w15 I aknowledge your private message here, since I'...

In forum Assembly and first prints troubleshooting

7 years ago
Bed leveling or Z axis issue and noises.

In forum Assembly and first prints troubleshooting

7 years ago
Share: