Notifications
Clear all
Cantchoose
Cantchoose
Skupina: Registrovaný
Přidal se: 2021/09/25
Eminent Member
2
I found out (most likely) what causes this and I can reprodu...

In forum Hardware, firmware and software help

před 1 year
Attaching files also doesn't seem to work for me.. Here's gc...

In forum Hardware, firmware and software help

před 1 year
Random, uneven, extra retraction (?) noise during print

In forum Hardware, firmware and software help

před 1 year
Yeah the only thing that comes to my mind is that ptfe tube ...

In forum How do I print this? (Printing help)

před 3 years
I guess you don't appreciate my drawing skills 🙁 it was sim...

In forum How do I print this? (Printing help)

před 3 years
I do, I very much would like to have it as I understand it's...

In forum How do I print this? (Printing help)

před 3 years
Hahah pretty much same story here. Difference was I think so...

In forum How do I print this? (Printing help)

před 3 years
Yeah support so far only mentioned stuff I already did coupl...

In forum How do I print this? (Printing help)

před 3 years
Small set screw that holds extruder motor gear - I figured t...

In forum How do I print this? (Printing help)

před 3 years
I instaled it recently, beginning of this week - toghether w...

In forum How do I print this? (Printing help)

před 3 years
PETG also came out great and that was fully enclosured. No...

In forum How do I print this? (Printing help)

před 3 years
I should've tested it using PETG.. I thought that those laye...

In forum How do I print this? (Printing help)

před 3 years
It lasted till half of cube. I didn't hear any clicking thro...

In forum How do I print this? (Printing help)

před 3 years
I am around 70% in second cube and it is so far flawless. Th...

In forum How do I print this? (Printing help)

před 3 years
I wanted to be 100% sure before I respond so I took extruder...

In forum How do I print this? (Printing help)

před 3 years
I got replacement extruder gears - there is no slack between...

In forum How do I print this? (Printing help)

před 3 years
Awesome video! Seems Ebox Lite is kind of best middle ground...

In forum How do I print this? (Printing help)

před 3 years
End of print was unfortunately quite bad, with next print (s...

In forum How do I print this? (Printing help)

před 3 years
Fully agree. I specifically wrote that my last filament was ...

In forum How do I print this? (Printing help)

před 3 years
I didn't. I will do that today to see if it helps. If this i...

In forum How do I print this? (Printing help)

před 3 years
Stránka 1 / 2
Share: