Prusa3D Forum

Notifications

Clear all

bumgarb42

Group: Registered

Joined: 2021/07/12

Active Member

	Thanks for that information, Jack. I'll say that my descrip... In forum Hardware, firmware and software help	4 years ago
	I'm new to 3D printing, but have my smooth sheet with PLA pe... In forum Hardware, firmware and software help	4 years ago
	Measured correlation between layer height, first layer calib... In forum General discussion, announcements and releases	4 years ago
	@diem Update: I disconnected and reconnected the hotbed and ... In forum Assembly and first prints troubleshooting	4 years ago
	@diem Thanks for the response. The bed was definitely NOT h... In forum Assembly and first prints troubleshooting	4 years ago
	First Layer Calibration "Bed Heating ..." forever In forum Assembly and first prints troubleshooting	4 years ago

Forum Statistics

595 Forums

68.7 K Topics

480.9 K Posts

12 Online

77.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed