Prusa3D Forum

Notifications

Clear all

buckettraveler

Groupe: Enregistré

A(ont) rejoint: 2020/06/29

Active Member

	How much weight can it hold on top? Dans le forum General discussion, announcements and releases	il y a 1 year
	Ah thanks, I thought I was being silly putting a paver, or a... Dans le forum Community mods	il y a 3 years
	In the enclosure? Did you put anything beneath the floor ti... Dans le forum Community mods	il y a 3 years
	Paver in enclosure or other ways to silence printer futher. Dans le forum Community mods	il y a 3 years
	Eh, I think I'm going to take it out, I hoped the quick rele... Dans le forum Assembly and troubleshooting	il y a 3 years
	Looks like it gets up to 26.1°C in the enclosure after a 3 h... Dans le forum Assembly and troubleshooting	il y a 3 years
	Leaving the PSU in the enclosure for the winter? Dans le forum Assembly and troubleshooting	il y a 3 years
	Best steel sheet for PETG? Dans le forum How do I print this? (Printing help)	il y a 3 years
	Oh wait, I was going to the wrong site, not the eshop but th... Dans le forum How do I print this? (Printing help)	il y a 5 years
	What to use to print the Lack enclosure parts? Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

585 Forums

68.4 K Sujets

478.7 K Messages

12 En-ligne

76.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé